Builder found guilty of failing to protect workers from falls

A Newcastle building company has been found guilty of failing to protect workers from falls.

The prosecution comes after a SafeWork inspector attended a construction site in Speers Point on 27 March 2018, after receiving an anonymous complaint about the lack of safety compliance at the site.

The company was issued a $ 3,600 fine and given improvement and prohibition notices by SafeWork NSW. The builder complied with the notices but challenged the fine.

The Downing Centre Local Court found that the company had failed to minimise the risk of a fall by failing to provide adequate fall protection and was fined $ 5,000 on 8 April.

“The inspector found there was no fall protection systems in place around the first-floor perimeter of the building, about three metres high, under construction at the site,” SafeWork NSW Executive Director Tony Williams said.

“In addition, four workers were observed working from height with no fall protection.

“More than 12,000 workers were injured after falling from a height between 2014 and 2017. Of those, 25 died and more than 240 were permanently disabled.

“Over the past three years, most serious falls were from two to four metres, approximately a single storey. These figures, or any death at work, are just unacceptable.

“This judgement sends a clear message that not only must builders provide adequate fall protection for workers, but that those systems must be used by workers to keep everyone on site safe. Safework’s action plan in finding the best safety solution for specific industries is highlighted in the Work Health and Safety Roadmap 2022. Our top priorities include construction, manufacturing and transport industries.”

The post Builder found guilty of failing to protect workers from falls appeared first on OHS News.

OHS News

Written by

No Comments Yet.

Leave a Reply